I have programmed key card for Laguna 2 ph
2 with Renault
Can Clip diagnostic interface. I share my operation procedure in
this blog with you.
Vehicle model:
Laguna 2 ph2
Tools required:
PC with window XP
or Win7
New key
Keys needed to be
operable.
Procedure in detail:
Turn on ignition
with a working key card
Start up the
Renault Can Clip
Go to the UCH
section
Enter the
configuration mode at the top
Choose encoding/reading
Select button
SC003 Spare/reserve
Enter 5938
followed by the enter when prompted for a code.
Now you need to
write down the ISK Code
Need the bytes
from 18 up to 23. Some cars do require up to byte 24
In the lower bar
you have the actual byte value (in this case the ISK code is 48FDA395AFC5)
Open Renault Pin
Extractor
Go to the ISK tab
Select your car
and enter the ISK code you just wrote down.
Click to button”
ISK TO PIN” Copy the calculated PIN code.
The section of the
Can Clip can be closed.
Go to secured encoding/reading, and choose
encode cards.
Remove the card
from the card slot and press continue.
Now we need to
present all the cards wanted to be operate with one at a time
Just follow the
commands on the screen.
The new card won’t
be recognized by the car yet. Don’t worry.
Now we have to
write the outcode, and use it to calculate another code with Renault Pin
Extractor.
Go back to Renault
Pin Extractor and go to the clip tab
Enter the outcode
you just got and Enter the Vin (vin is at the bottom of your screen)
Paste the Pin Code
we copied earlier and press Calculate
Copy the
Calculated Incode, go back to Can Clip and paste the incode.
Present the cards
again one by one and follow the on screen instructions
Now you can enjoy
your new key card.
Remove the card
and let the pc write all the data away.
RF sync should be
OK
DONE!
